Tabla de seleccion descontaminacion de los gases
The table below summarizes much of the information in the gas scrubbing nozzle section of the BETE Limited website. It is intended to be handy reference guide to aid nozzle selection. Full data on each of the nozzles listed can be accessed by clicking on the boxes in the left hand column of the table below. The data sheets will open in a separate tab to allow easy comparisons between multiple product sheets.
Nozzle Type | Design Type | Spray Characteristics | Reactivity of spray (surface area) | Reach / momentum of spray | Flow rate range | Gas Scrubbing uses |
| Spiral full cone | Fine spray Concentric rings of spray Abrasion resistant Clog resistant | Average | Good | 2.26- 10700 | Wet Scrubbing over large areas in abrasive environments |
| Spiral full cone | Fine spray Concentric rings of spray Abrasion resistant Clog resistant Extra large free passage | Average | Good | 2.26- 10700 | Wet Scrubbing over large areas in abrasive environments |
| Spiral full cone | Fine spray Concentric rings of spray Clog resistant | Average | Good | 2.26- 10700 | Wet Scrubbing over large areas |
| Spiral full cone | Fine spray Concentric rings of spray Clog resistant | Average | Good | 0.534-14.7 | Dry Scrubbing needing low flow rates |
| Air atomising | Very fine spray Uniform spray Very low flow rate | Excellent | Average | 0.023-1.5 | Dry Scrubbing needing very low flow rates |